NEWS
NEWS
/
/
Precautions in plastic mold design

Precautions in plastic mold design

  • Author:
  • Origin:
  • Time of issue:2021-11-02 09:42
  • Views:

【Summary】:The feed inlet shall be set at the thicker part of the product to ensure smooth and complete mold filling. It shall be set at a place that does not affect the appearance and function of the product as far as possible. The pull rod can be set at the edge or bottom and in the cold cavity near the gate to facilitate the demoulding of runner, large or flat products. It is recommended to use multi-point feeding to prevent product warpage, deformation and material shortage.

Precautions in plastic mold design

(Summary description)The feed inlet shall be set at the thicker part of the product to ensure smooth and complete mold filling. It shall be set at a place that does not affect the appearance and function of the product as far as possible. The pull rod can be set at the edge or bottom and in the cold cavity near the gate to facilitate the demoulding of runner, large or flat products. It is recommended to use multi-point feeding to prevent product warpage, deformation and material shortage.

  • Categories:News
  • Author:
  • Origin:
  • Time of issue:2021-11-02 09:42
  • Views:0
Information

The feed inlet shall be set at the thicker part of the product to ensure smooth and complete mold filling. It shall be set at a place that does not affect the appearance and function of the product as far as possible. The pull rod can be set at the edge or bottom and in the cold cavity near the gate to facilitate the demoulding of runner, large or flat products. It is recommended to use multi-point feeding to prevent product warpage, deformation and material shortage.

Scan the QR code to read on your phone

Copyright 2021. hightech-mould. All rights reserved. 粤ICP备2021078526号  Powered by www.300.cn